I have a CM4 interfaced with a regular picam and an Analog Devices ToF module, the pica uses regular csi connector while the TOF module uses FH26W-25S-0.3SHW(60) https://www.digikey.com/en/products/det ... 60/5132498
When mounted there is a strain in the cable as pictured below Image may be NSFW.
Clik here to view.
and a streaking pattern is observed from feeds on the both modules.
Image may be NSFW.
Clik here to view.
It however disappears, either if the cables are left straight flat on the table, glued down, both solutions do not actually solve the issue in long term.
Any Pointers?
Image may be NSFW.
Clik here to view.
Image depicting pressure on the cable/connector that resolves the issue temporarily
When mounted there is a strain in the cable as pictured below Image may be NSFW.
Clik here to view.
and a streaking pattern is observed from feeds on the both modules.
Image may be NSFW.
Clik here to view.
It however disappears, either if the cables are left straight flat on the table, glued down, both solutions do not actually solve the issue in long term.
Any Pointers?
Image may be NSFW.
Clik here to view.
Image depicting pressure on the cable/connector that resolves the issue temporarily
Statistics: Posted by akurhade — Mon Jan 22, 2024 2:52 pm
