Compute Module • Re: Pi CM4 EUROCARD io Board ( Home-Lab ) Update

UPDATE 8

I wanted to show you the different penal's and the 3d stuff this update, but plans changed slightly since the Board arrived early Yesterday evening. So what was supposed to be in this update will come in the next update.

TL;DR the board has arrived, and works as far as i can say.

Things i checked:

Checked all voltages before plugging in the CM4 - passed
HDMI 0 and 1 - passed
HDMI sound - passed
USB int and ext - passed
Eathernet -passed
PI cam port 0 and 1 -passed
SD slot - passed
GPIO - passed
PI Display 0 and 1 - N/A
USB slave - passed
PCIE Header - Voltages passed rest N/A need a daughter board

Since the rest works, I'm assuming the PI display ports work as well, but I have no Display to test it. So i'll leave it as N/A.
Currently, the board is running 10h of crap rave (yes my neighbors love me) on a lower spec CM4 (2gb) if it does that without burning down my apartment I will stress test the board so expect a tiny update tomorrow.
I ran out of space on my desk and I have a tiny apartment so the ground what I have to work with sorry
i soldered the Ethernet port and DC jack, I did a horrible job, but it works
I assembled the front panel and everything fits perfectly, which was a positive surprise. Next update, you'll get the different versions next to each other.

What's next ?
1. stress test the board
2. change the 3D printed Panel holder (just 2mm) since the display screws are a little too close
3. finishing the Code for the display
4. slowly testing the other 4 boards

till then, have a nice day

Statistics: Posted by MikeGotWine — Fri Nov 08, 2024 10:11 am

---