Today, the display went off. There were only white stripes over the screen. Reinserting "edt_ft5x06" module really has no influence, it is "tc358762" module that needs to be reinserted to make it working again. (however, this kills X server which needs to be restarted then).
SHT31 sensor works correctly now but it is the only device connected to i2c1. If SCL is being held low by this sensor in faulty state, is it possible to put it high by software?
SHT31 sensor works correctly now but it is the only device connected to i2c1. If SCL is being held low by this sensor in faulty state, is it possible to put it high by software?
Statistics: Posted by kolsi — Tue Jun 11, 2024 6:35 am
