Everything works as expected (always a nice feeling), but what I noticed is that the GPIO4 pin after one or two iterations stops working.
If I restart the program again, it works a couple of times then stops.
This was tested on a Raspberry Pi Zero 2W running Bullseye image.
Will try the same test on a RPi 4 to see what happens there.
Any ideas why is this happening?
Has your OS assigned any other purpose to GPIO4? Such as a default interface for 1-Wire?
Ref: https://pinout.xyz/pinout/1_wire
Statistics: Posted by B.Goode — Sun May 05, 2024 11:25 am